Same-day fridge repair across Broward County, licensed and warrantied
Refrigerator repair Tamarac FL done right the first time
Refrigerator repair Tamarac FL homeowners can actually schedule - we diagnose, quote, and fix in one visit. Our techs handle Whirlpool, Samsung, LG, GE, Maytag, Frigidaire, Bosch, Sub-Zero and KitchenAid, from a warm fridge to a dead ice maker. If your food is thawing in a Tamarac kitchen right now, call (866) 334-5109 and we will get a fridge repair Tamarac FL tech to you today.
Live phone supportUpfront optionsBacked workmanship
What's included
What our refrigerator repair includes
Every call covers a full diagnostic of the cooling, defrost, and water systems, a flat repair quote, and a test run before we leave. Parts are quoted separately from labor so you can see exactly where the money goes. Sealed-system work, refrigerant recharge, and commercial units are handled on the same visit when the parts are on the truck.
Full cooling diagnostics
We test the compressor draw with a clamp meter, check the thermostat and control board with a multimeter, and scan the evaporator with a thermal camera. That combination catches most cooling faults in under 30 minutes.
Defrost and drain service
Freezer frost buildup and water leaks usually trace to the defrost heater, bi-metal thermostat, or a clogged drain line. We test all three, clear the line, and confirm the defrost cycle completes.
Water and ice maker repair
We check the water inlet valve, filter housing, and ice maker module. A dead ice maker is often a $60 valve, not a $400 unit, and we will tell you which one you have.
Sealed-system service
If the refrigerant charge has drifted, we locate the leak, repair it, evacuate the line with a vacuum pump, and recharge R-134a or R-600a to manufacturer spec. EPA Section 608 certification is required and we hold it.
Door gasket and seal check
A worn door gasket lets cold air escape and makes the compressor run nonstop. We test the seal with a dollar-bill pull and replace the gasket if it fails, which often cuts the electric bill too.
Post-repair test run
We run the fridge 20 to 30 minutes and confirm the freezer holds below 0 degrees Fahrenheit before we leave. If it does not hit temperature, we stay and find out why.
Service overview
Refrigerator repair Tamarac FL: what the job really involves
Refrigerator repair Tamarac FL is the diagnostic and mechanical work that restores cooling, defrost, water, and ice functions to a household or commercial fridge. A proper call starts with a clamp meter reading on the compressor circuit, a multimeter check of the thermostat and control board, and a thermal camera pass across the evaporator coils. From there we test the door gasket seal, the water inlet valve, the drain pump, and the defrost heating element. Most failures trace back to a capacitor, a clogged drain line, or a refrigerant charge that has drifted.
Tamarac kitchens run fridges hard. The Broward County humidity pushes condensers to work overtime, and a garage unit in Westwood or Heathgate can see 95-degree ambient air by August. When a fridge stops cooling, you have roughly four hours before dairy and meat hit the danger zone. That is why we run same day refrigerator repair Tamarac FL calls seven days a week, including the 33321, 33319, and 33359 ZIP codes. If you are searching for refrigerator repair near me Tamarac FL at 9 p.m. with a warm freezer, we answer.
How we workWe verify the cause, compare realistic options, and confirm the repair before we leave.
The service timeline
How our refrigerator repair process works
The process flexes to the condition, but these checkpoints keep decisions clear.
Phone triage
You call (866) 334-5109 and describe the symptom: not cooling, leaking water, ice maker dead, freezer frosting over. We ask for the brand, model, and ZIP, then book a two-hour arrival window. Takes about four minutes.
On-site diagnosis
The tech pulls the fridge out, checks the compressor draw with a clamp meter, tests the thermostat and control board with a multimeter, and runs a thermal camera over the evaporator. You get the finding in plain language, usually within 30 minutes.
Flat-price approval
We quote the repair as a single number covering labor and the part. You approve or decline on the spot. No pressure, no paperwork maze. If the fix is not worth it on a 15-year-old unit, we will tell you straight.
Repair and test
We replace the failed component, recharge refrigerant if the sealed system needs it, and clear any drain line blockage. Then we run the fridge for 20 to 30 minutes and confirm the freezer holds below 0 degrees Fahrenheit before we pack up.
Walkthrough and cleanup
We show you what failed, what we replaced, and what to watch for. Floors get wiped, the fridge goes back in place, and you get your invoice by text. Most jobs wrap in 90 minutes to two hours.
Tools & methods
Tools and methods we use
Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.
Clamp meter
Measures the compressor's current draw to confirm whether the motor is pulling normal amps or failing. A high or zero reading points straight to the compressor or start relay.
Multimeter and voltage tester
Tests the thermostat, control board, heating element, and capacitor for continuity and correct voltage. This is how we isolate an electrical fault from a mechanical one.
Refrigerant gauge manifold
Reads high-side and low-side pressure on sealed-system jobs so we can confirm the charge and spot a leak before recharging R-134a or R-600a.
Vacuum pump
Pulls a deep vacuum on the line set after a sealed-system repair. Skipping this step leaves moisture in the system and kills the compressor within months.
Thermal camera
Shows temperature differences across the evaporator coils and door seals. A cold spot or a warm band tells us exactly where the fault is without guesswork.
Socket set, screwdriver set, and pliers
Standard hand tools for pulling panels, removing fan motors, and swapping valves. We carry a full set so we are not running back to the truck mid-repair.
Putty knife
Used to release door gaskets and trim panels without tearing the seal or cracking plastic. Small tool, saves a lot of damage on older units.
Use cases
When to call for refrigerator repair
These examples show how the service framework adapts rather than forcing every call through one repair.
Water on the floor in Tamarac Village
A condo owner in Tamarac Village had water pooling under the crisper drawers for a week. The cabinet base was starting to swell and there was visible mold on the drain pan. → We cleared a heavily clogged defrost drain line, flushed it, and replaced the drain pan. Ninety minutes on site, $210 total. The floor stayed dry through the next month of rain.
Dead reach-in cooler in University Park
A deli near University Park lost its main reach-in cooler on a Tuesday morning. Product was warming and lunch service was three hours away. → Our commercial tech arrived before noon, diagnosed a failed control board, and swapped it. The cooler was back under 40 degrees Fahrenheit by 2 p.m. Total cost: $480 including the board.
Problems we solve
Fridge problems we fix in Tamarac
Most refrigerator calls fall into five buckets: not cooling, leaking water, frosting up, dead ice maker, or a control board that has failed. Here is what each one costs you if you wait, and how we handle it.
Refrigerator not cooling but freezer still works
This is almost always a failed evaporator fan motor or a clogged air damper between the freezer and fridge sections. We test the fan, clear the damper, and confirm cold air is moving before we leave. Typical repair: $200 to $320.
Water pooling under the crisper drawers
We pull the fridge, clear the drain line with a flush and vacuum, and test the drain pan and drain pump. Most jobs finish in 60 to 90 minutes and cost $180 to $260.
Freezer frost buildup on the back wall
We test the defrost heater, bi-metal thermostat, and defrost timer or control board, then replace the failed part. A full defrost cycle check confirms the fix. Typical cost: $220 to $400.
Ice maker not working or making hollow cubes
We test the water inlet valve, check the fill tube for ice blockage, and verify the ice maker module cycles. Most fixes are a valve or module swap, $190 to $350.
Pricing process
What refrigerator repair costs in Tamarac
$180 - $650 depending on the failed part and whether sealed-system work is needed
Failed component type
A capacitor or thermostat sits at the low end, around $180 to $260. A control board runs $280 to $520. A compressor replacement is the top of the range and often makes an older fridge not worth repairing.
Sealed-system work
Any job that opens the refrigerant circuit, like a leak repair or compressor swap, adds labor for recovery, evacuation, and recharge. That pushes the total to $450 to $650 and requires EPA Section 608 certification.
Brand and parts availability
Whirlpool, GE, Samsung, and LG parts are widely stocked and cheaper. Sub-Zero, Bosch, and KitchenAid built-ins use proprietary parts that cost more and may need to be ordered.
How much does Refrigerator repair cost in Tamarac FL?
Most refrigerator repairs in Tamarac run $180 to $450 in 2026, and sealed-system work with a refrigerant recharge can reach $650. A simple capacitor or thermostat swap sits at the low end; a compressor replacement sits at the top. We quote the flat price after diagnosis, before any work starts, so the number you hear is the number you pay.
Who fixes refrigerators in Tamarac Florida?
SolidRevive does, along with a handful of other licensed shops in Broward County. We have serviced Tamarac since 2022 and cover every ZIP here, including 33321, 33319, and 33359. Our techs are EPA Section 608 certified for refrigerant work and carry a Florida state appliance repair license. Call (866) 334-5109 and we will book you a same-day window.
Why is my refrigerator leaking water in Tamarac?
A clogged defrost drain line causes about 70 percent of fridge water leaks we see in Tamarac, and the rest are usually a cracked water inlet valve or a failed drain pump. High humidity here speeds up algae and mineral buildup in that drain line. We clear the line, flush it, and test the valve in one visit, typically 60 to 90 minutes.
How long does a refrigerator repair take?
Common repairs take 60 to 120 minutes on site. A capacitor, thermostat, door gasket, or control board swap is usually done inside 90 minutes. Compressor or sealed-system jobs can run three to four hours because we have to evacuate the line, replace the part, and recharge refrigerant R-134a or R-600a to spec. We tell you the expected duration when we quote.
Related services
Related Services
appliance repair near me
If your fridge is not the only unit acting up, we handle the whole kitchen in one trip. Tamarac customers often bundle a fridge call with a dishwasher or oven issue to save a second service fee.
Emergency appliance repair
A fridge that dies at 11 p.m. with a freezer full of meat is an emergency. We run after-hours routes across Tamarac and Broward County for exactly that scenario, and we answer the phone, not a machine.
Washing machine repair
Washer spin cycle failure and drain problems are our second most common Tamarac call. Same techs, same flat pricing, same warranty. If your laundry pair is aging together, we can look at both.Ready when you are
Get Refrigerator repair Tamarac FL scheduled today
A warm fridge does not get better on its own, and every hour costs you food. Call (866) 334-5109 and we will book a same-day window with a licensed, insured tech. Flat quote before work, workmanship warranty after.
Talk with the local team
Request Refrigerator repair
Call (866) 334-5109 or email [email protected] and we'll get you on the schedule. Our phones are answered 24/7 for emergencies, and standard appointments run Monday through Friday, 8 a.m. to 6 p.m. Most Tamarac calls get a same-day or next-morning window.